Preparation for inspection before Wet Wipes Production Line products start-up

2021-09-15


Check the equipment daily before start-up, clean it after use, and check the condition of Wet Wipes Production Line products in a timely manner. If there is a problem, it needs to be solved in time to ensure that there are no abnormal problems before starting.

Wet Wipes Production Line products

Robots should first check to see if they need oil, so that the equipment can always be lubricated and not wearing parts due to lack of oil.

Then check the feeding situation, the slitting and folding part of Wet Wipes Production Line products to see if the raw material needs to be prepared in advance, whether the slitting device is aligned, and whether there is any displacement change in the distribution of the folded part.

At the same time, check the liquid filling device to see if the solution is sufficient and whether it needs to be prepared in time for backup. Then come down and check that the label wrapping film is in place.

When re-checking the installation of each link, it should be dealt with in time to prevent the connection parts from loosening and tightening.

There is also a focus on inspection and inspection of non-woven joints. Because the raw rolls of Wet Wipes Production Line products are connected automatically, it is necessary to check that the double-sided tape is in good condition, so as not to know when the fabric is finished due to seam problems. It is important to know that re-threading is time-consuming.

undefined

undefined