A complete set of equipment inspections are to be carried out before the Wet Wipes Production Line starts up


Not all wipes factories operate at full capacity 24 hours a day, and most wipes factories operate full-time day or two-shift operations, so operators and technicians must be prepared for equipment safety inspections before the Wet Wipes Production Line starts.

Check the device every day before starting, clean it after use, and check the condition of the wiper in time. If there is a problem, it needs to be solved in time to ensure that there are no abnormal problems before starting.

Automated wipes production equipment should first check whether oil needs to be refueled so that the equipment can always be lubricated and parts will not be worn due to lack of oil.

Wet Wipes Production Line

Whether it is a small wet wipe machine or a large Wet Wipes Production Line, the feeding position is the first check, check the feeding situation, the slitting and folding part of the Wet Wipes Production Line, see if the raw materials need to be prepared in advance, whether the slitting device is aligned, and folded Whether there is a displacement change in the distribution of the part.

In addition, check the wipe solution to see if the solution is sufficient and whether it needs to be prepared in time for backup. Then go down to check whether the label packaging film is in place, whether the label is in place, and whether the opening is appropriate.

When re-checking the installation of each link, it should be dealt with in time to prevent the connection parts from loosening and tightening.

There is also a key inspection and inspection of non-woven joints, which are mainly used for large-scale wet tissue equipment such as 20-channel wet wipes machine, 16-channel automatic wet tissue machine, and 12-channel automatic wet tissue machine. Because the stock rolls are automatically attached, it is necessary to check that the double-sided tape is intact, so as not to know when the fabric is finished due to seam issues.